Speed Brushless Tower Pro 30 A

รหัสสินค้า: 000281

รายละเอียด: Speed Brushless ราคาประหยัด1050บาท

Tower Pro 30A Brushless Motor Electric Speed Controller
-Size 45 x 25 x 10mm
-Weight 22g
-Continuous current limit 30A
-Maximum current limit 40A (within 5 second)
-Input voltage from 7.2V to 12V
-Suitable for Nicd, NiMH and Lipo batteries
-Selective cut-off voltage at 5V or 7.5V by a jumper switch
-Can be programmed to switch the brake ON / OFF
-Number of FET = 15 pieces
-High rate PWM 8K
-Auto Timing
-BEC 1.5A
-Self-adjusting throttle range
-Suitable for JR/Futaba/Hitec/GWS
-An English operation manual is included
Specifications:
1.Type A: Auto detect the number of cells of your battery pack and set up the cut-off voltage: 5.3V (2 cells)/8.3V(3 cells).
Type B: 2/3 Li-poly switch: 2-pin jumper in:2-cell Li-Poly cutoff

2-pin jumper out: supports 3-cell Li-Poly cutoff
2.Reversing the motor direction is achieved by the exchanging the position of any two wires connected to the motor.
3.Maximum current is 40A which should not last over 5 seconds.
4.Wrong polarity of power pack may result in severe damage.
5. 4 servos can be used when the voltage is lower than 7.4V (2 cells Li-poly); and 3 servos only recommanded when th voltage is 11.1V (3 cells Li-poly) to prevent overheat of BEC system.

Note: When using economical class micro servos, it is necessary to reduce the number of servos by one.

**The speed controller is supplied with the brake activated .If you want to turn off the brake, do the following:

- Switch on the transmitter and move the stick to full throttle.
- Connect the main power pack and turn on the receiver switch (if used).
- Wait 5 seconds.
- After 5 seconds you will hear 4 tones.
- Move the throttle stick fast to the closed position, you will hear two beeps.
- The brake is now turned off. The brake setting is memorized, that means it will not change after disconnecting the main power pack. When turning on the speed controller with the brake active, you will always hear one beep. When the brake is turned off you will hear a double beep. If you want to activate the brake again, repeat the procedure.

The speed controller will turn-off the motor when the main power pack voltage falls under 5,3 V/8,3V or reaches 0,7V/ cell .It depends on which occurs first. Temperature overload protection is built into the speed controller, it turns off the motor when the temperature reaches 110บcentigrade .These speed controllers are equipped with protection functions that take care of correct start and operation of the motor across the whole range of revolutions and current. Do Not connect the speed controller to just any kind of power source. Take care to ensure the right polarity of Li-Poly power packs. When using the wrong polarity, the speed controller will be severely damaged.